Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: This is a self-retaining fastener joint that does not require thread locking compounds. Do not attempt to clean the threads with a standard tap. If a standard tap is used, damage to the joint threads will occur.

NOTE: Refer to Fastener Notice .

Fig 1: Locating Front Brake Caliper Mounting Bracket Bolts

Courtesy of GENERAL MOTORS CORP.

Install the brake caliper mounting bracket to the steering knuckle.
Install the brake caliper mounting bracket bolts (1).
Tighten: Tighten the bolts to 115 N.m (85 lb ft).

Fig 2: View Of Brake Pad Retainers At Caliper Bracket

Courtesy of GENERAL MOTORS CORP.

Apply a very thin coating of high temperature silicone brake lubricant to the pad hardware mating surfaces (1) of the caliper bracket only.
Clean the brake pad mating surfaces of the brake pad retainers (2).
Install the brake pad retainers (2) to the brake caliper bracket.

Fig 3: View Of Brake Caliper Supporting With Heavy Mechanic's Wire

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The wear sensor equipped disc brake pad must be mounted inboard of the rotor with the leading edge of the sensor facing the brake rotor during forward wheel rotation, or at the top of the pad when installed in vehicle position.

Install the brake pads (2) to the brake caliper bracket.
Remove the support (1) and reposition the brake caliper over the brake pads and to the mounting bracket. Refer to Front Brake Caliper Replacement .