LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H3 Adventure, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 467 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Replacement (LH2) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Upper Generator Mounting Bolts
    GM887719Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (LHD With Top Post)  or Battery Negative Cable Disconnection and Connection (Side Post) .
  2. Remove the generator drive belt. Refer to Generator Belt Replacement .
  3. Remove the upper generator mounting bolts (1, 3).
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  5. Remove the front air deflector. Refer to Front Air Deflector Replacement .
  6. Cut the tie strap securing the wiring harness to the generator.
    7. Fig 2: Generator Electrical Connector
    GM887723Courtesy of GENERAL MOTORS CORP.
  7. Remove the lower generator mounting bolt.
  8. Lift the generator off of the mounting bracket in order to gain access to the connector and the generator output BAT terminal nut.
  9. Disconnect the wire harness electrical connector from the generator.
  10. Reposition the protective boot from the generator output battery terminal for access.
  11. Remove the generator output battery terminal nut and disconnect the battery positive lead from the generator.
  12. Remove the generator from the vehicle.
scientia non olet · About LEMON Manuals