LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H3 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Disc Brake System) >> Repair Instructions >> Brake Caliper Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Brake Caliper
    GM1241368Courtesy of GENERAL MOTORS CORP.
  1. Position the brake caliper assembly on the mounting bracket.
    2. Fig 2: View Of Brake Caliper Pin Bolts
    GM1241367Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the guide pin bolts.

    Tighten:  Tighten the guide pin bolts to 40 N.m (29 lb ft).

  3. Remove the rubber plugs from the brake hose.
    4. Fig 3: View Of Brake Hose Gaskets & Bolt
    GM1360988Courtesy of GENERAL MOTORS CORP.
  4. Install the NEW copper gaskets and bolt on the brake hose.
    5. Fig 4: View Of Brake Hose
    GM1339849Courtesy of GENERAL MOTORS CORP.
  5. Install the brake hose on the brake caliper.

    Tighten:  Tighten the brake hose bolt to 40 N.m (29 lb ft).

  6. Bleed the system. Refer to Hydraulic Brake System Bleeding (Manual) or Hydraulic Brake System Bleeding (Pressure) in Hydraulic Brakes.
    7. Fig 5: View Of Tire & Wheel Assembly
    GM1253298Courtesy of GENERAL MOTORS CORP.
  7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals