LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H3 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Control System - 3.5L (L52) - Introduction) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement-Exhaust >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lightly lubricate the O-ring seal with clean engine oil.
    2. Fig 1: View Of Exhaust Camshaft Sensor
    GM858172Courtesy of GENERAL MOTORS CORP.
  2. Install the exhaust CMP sensor into the cylinder head.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the exhaust CMP sensor bolt.

    Tighten:  Tighten the CMP sensor bolt to 10 N.m (89 lb in).

    4. Fig 2: View Of CMP Sensor Connector, Exhaust Camshaft Actuator Connector & Engine Wiring Harness Retainer
    GM1350714Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector (4) to the exhaust CMP sensor (5).
scientia non olet · About LEMON Manuals