Circuit Description

Moving the ignition switch to the START position signals the body control module (BCM) that engine crank has been requested. The BCM verifies that theft is not active and sends a serial data message to the powertrain control module (PCM) requesting engine start. The BCM also energizes the RUN/CRANK RELAY. When the RUN/CRANK RELAY switch side closes and the vehicle is in Park/Neutral or with the clutch fully depressed, if equipped, supply voltage is applied to the PCM CNTRL relay coil. The PCM verifies the transmission is in Park/Neutral or if the clutch is fully depressed, if equipped. The PCM will then ground the control circuit of the PCM CNTRL relay, closing the switch suppling voltage to the starter solenoid. On some vehicles the starter will continue to crank the engine with the key released until it starts, the crank command has timed out to prevent excessive heat build up in the starter circuitry or the PCM receives an engine run flag.