LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H3 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Clutch Pressure Plate, Bolts, Driven Disc, Dowel Pins & Flywheel
    GM1302140Courtesy of GENERAL MOTORS CORP.
  1. Install the clutch pressure plate (2) and driven plate (3) to the dowel pins (4) on the flywheel (5).
  2. Install the clutch pressure plate bolts (1) finger tight.
  3. Use the Snap-On A145 Clutch Aligner Set, or equivalent, to align the clutch driven plate (3) to the clutch pilot bearing.
    4. Fig 2: Clutch Pressure Plate Bolts Tightening Sequence
    GM71490Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Tighten the NEW clutch pressure plate bolts in the sequence shown.

    Tighten: 

    1. Tighten the clutch pressure plate bolts in sequence to 20 N.m (15 lb ft).
    2. Use the J 36660-A  in order to tighten the clutch pressure plate bolts in sequence an additional 45 degrees.

  5. Install the transmission. Refer to Transmission Replacement (RWD) or Transmission Replacement (4WD) in Manual Transmission - Aisin AR5.
scientia non olet · About LEMON Manuals