Removal Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Before cutting out a stationary window, apply a double layer of masking tape around the perimeter of the painted surfaces and inner trim of the window.

Fig 1: View Of Body Side Stationary Window

Courtesy of GENERAL MOTORS CORP.

Carefully spread the handle retainer outward in order to release the latch pin from the latch.
Remove the latch pin from the latch.
Remove the seat belt retractor. Refer to Seat Belt Replacement - Front (Regular and Extended Cab) or Seat Belt Replacement - Front (Crew Cab) in Seat Belts.
Open the door in order to access the rivets.

CAUTION: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.

Cover to protect the following parts from broken glass:
- Upper dash pad
- Defroster outlets and A/C outlets
- Seats and carpeting

CAUTION: Refer to Glass And Sheet Metal Handling Caution in Cautions and Notices.

Drill out the rivets retaining the window assembly.
Thoroughly clean all metal particles that may have lodged inside the body panel.
Remove the window assembly from the vehicle.