LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H3 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Hydraulic Brake System) >> Repair Instructions >> Brake Hose Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Brake Hose
    GM1339849Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: DO NOT reuse the old copper gaskets. Always use NEW metal copper gaskets.
  1. Install the copper gaskets on the brake hose.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the brake caliper bolt to the brake caliper.

    Tighten:  Tighten the brake hose bolt to 40 N.m (32 lb ft).

  3. Remove the plug or cap from the exposed brake pipe fitting.
  4. Install the brake hose to the brake pipe.
    5. IMPORTANT: Ensure that the brake hose is not twisted and does not come in contact with any of the suspension components.
  5. Using a backup wrench on the brake pipe fitting, tighten the brake hose fitting.

    Tighten:  Tighten the brake hose fitting to 19 N.m (14 lb ft).

    6. Fig 2: View Of Front Brake Hose Retaining Clip
    GM1253275Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that the retaining clip is properly seated.
  6. Install the new brake pipe retaining clip.
  7. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual)  or Hydraulic Brake System Bleeding (Pressure) .
    8. Fig 3: View Of Tire & Wheel Assembly
    GM1253298Courtesy of GENERAL MOTORS CORP.
  8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  9. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
scientia non olet · About LEMON Manuals