LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H3 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Antilock Brake System And Traction Control System) >> Diagnostic Information and Procedures >> ABS Indicator Inoperative >> Test Description

Test Description

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

  1. 2:  This step tests if the IPC is able to illuminate the ABS indicator during the bulb check.
ABS Indicator Inoperative

Step Action Yes No
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2 
  1. Turn OFF the ignition for 5 seconds.
  2. Turn ON the ignition while observing the Antilock Brake System (ABS) indicator.
Does the ABS indicator illuminate?		 Go to Diagnostic Aids Go to Step 3 
3 Replace the instrument panel cluster (IPC). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.
Did you complete the replacement?		 Go to Step 4  -
4
  1. Turn OFF the ignition for 5 seconds.
  2. Turn ON the ignition while observing the ABS indicator.
Does the ABS indicator illuminate?		 System OK Go to Step 3 
scientia non olet · About LEMON Manuals