LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H3 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Supplemental Inflatable Restraint System) >> Repair Instructions >> SIR Disabling and Enabling Zone 5 >> Enabling Procedure

Enabling Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the key from the ignition.
    2. Fig 1: View Of Connector Position Assurance (CPA) & Steering Wheel Module Yellow 4-Way Connector
    GM819731Courtesy of GENERAL MOTORS CORP.
  2. Connect the I/P module yellow 4-way inline connector C208 (2) located above the driver side kick panel.
  3. Install the CPA to the I/P module yellow 4-way inline connector C208 (2) located above the driver side kick panel.
    4. Fig 2: Locating SIR Fuse
    GM1293224Courtesy of GENERAL MOTORS CORP.
  4. Install the SIR fuse to the fuse block (1) located in the underhood fuse block.
  5. Staying well away from all air bags, turn ON the ignition, with the engine OFF.
    1. The AIR BAG indicator will flash 7 times.
    2. The AIR BAG indicator will then turn OFF.
  6. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information, if the AIR BAG indicator does not operate as described.
scientia non olet · About LEMON Manuals