LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H3 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Roof Rail Module Replacement - Front (Regular and Extended Cab) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Retaining Bolts & Forward Curtain Clip (Regular & Extended Cab)
    GM1276902Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the 3 bolts (1) retaining the roof rail air bag module to the roof.

    Tighten:  Tighten the roof rail air bag module bolts to 9 N.m (79 lb in).

  2. Install a new forward curtain clip (2).
  3. Install the bolt (5) retaining the rear curtain to the roof.

    Tighten:  Tighten the roof rail air bag curtain bolts to 9 N.m (79 lb in).

  4. Install the rear tether bolt (3).

    Tighten:  Tighten the roof rail air bag rear tether bolt to 9 N.m (79 lb in).

    5. Fig 2: View Of Roof Rail Module Connector
    GM1276857Courtesy of GENERAL MOTORS CORP.
  5. Install the clips (3) to the pillar.
  6. Install the roof rail air bag forward tether bolt (3).

    Tighten:  Tighten the roof rail air bag forward tether bolt to 9 N.m (79 lb in).

  7. Connect the roof rail air bag electrical connector (1).
  8. Install the headliner. Refer to Headliner Replacement (Crew Cab) or Headliner Replacement (Extended Cab) or Headliner Replacement (Regular Cab) in Interior Trim.
  9. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2  and SIR Disabling and Enabling Zone 6 .
  10. Install the head restraints from the front seats. Refer to Head Restraint Replacement - Front Seat in SIR.
scientia non olet · About LEMON Manuals