LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H3 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Body Rear End) >> Repair Instructions >> Latch/Support Cable Assembly Replacement - Endgate >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Endgate Latch Rods & Retaining Clips
    GM1245380Courtesy of GENERAL MOTORS CORP.
  1. Open and support the endgate.
  2. Remove the endgate cover. Refer to Endgate Cover Replacement  .
  3. Disconnect the clips (1) retaining the latch rods (2) to the handle.
  4. Remove the latch rods (2) from the retaining clips (1).
    5. Fig 2: View Of Endgate Support Cables
    GM1245392Courtesy of GENERAL MOTORS CORP.
  5. Remove the support cable (1) from the endgate striker bolt by sliding the cable forward and off the striker bolt head.
    6. Fig 3: View Of Latch/Support Cable Assembly
    GM1245387Courtesy of GENERAL MOTORS CORP.
  6. Remove the bolts retaining the latch/support cable assembly to the endgate.
  7. Remove the latch assembly from the endgate.
scientia non olet · About LEMON Manuals