LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H3 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 28 (Body Rear End) >> Repair Instructions >> Endgate Cover Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Endgate Cover
    GM1245393Courtesy of GENERAL MOTORS CORP.
  1. Install the endgate cover to the endgate.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the screws retaining the endgate cover to the endgate, starting at the hole marked with the triangle (1).

    Tighten:  Tighten the endgate cover screws to 2.5 N.m (22 lb in) starting at the bolt hole marked with the triangle (1).

  3. Close the endgate.
scientia non olet · About LEMON Manuals