LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H3 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Steering Wheel & Steering Column) >> Repair Instructions >> Shift Lever Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Shift Lever, Seal (Boot), Screw & Upper Trim Cover
    GM419648Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The shift lever seal must be installed on the narrow end of the shift lever (base).
  1. If necessary, install the shift lever seal (2) onto the shift lever assembly (4).
  2. Install the shift lever assembly (4) to the steering column.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the shift lever screw (3) into the shift lever assembly (4).

    Tighten:  Tighten the screw to 1.5 N.m (13 lb in).

  4. Slide the shift lever seal (2) down the shift lever assembly (4).
  5. If necessary, install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  6. Align the shift lever seal into the steering column trim covers.
  7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals