LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H3 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Steering Wheel & Steering Column) >> Repair Instructions >> Multifunction Turn Signal Switch Housing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Multifunction Turn Signal Switch Mounting Plate
    GM1492306Courtesy of GENERAL MOTORS CORP.
  1. Slide the switch mounting plate onto the steering column shaft.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install 2 washer head screws into the switch mounting plate.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  3. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals