LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H3 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Steering Wheel & Steering Column) >> Repair Instructions >> Linear Shift Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Park Lock Cable At Ignition Lock Cylinder
    GM324874Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR Caution in Cautions and Notices.
  1. Disable the SIR System. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  2. Remove the shift lever. Refer to Shift Lever Replacement .
  3. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  4. Insert a small screwdriver into the slot on the ignition lock cylinder case and push against the locking tab to remove the park lock cable (1).
  5. The steering column lock cylinder MUST be in the OFF-LOCK position.
    6. Fig 2: View Of Automatic Transmission Shift Lock Control Actuator
    GM324906Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the automatic transmission shift lock control connector.

    Use a small screwdriver to gently pry the automatic transmission shift lock control from the steering column jacket assembly.

    7. Fig 3: View Of Linear Shift Assembly
    GM1492305Courtesy of GENERAL MOTORS CORP.
  7. Remove the 3 oval head tapping screws from the linear shift assembly.
  8. Remove the linear shift assembly from the steering column support assembly.
scientia non olet · About LEMON Manuals