LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H3 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Steering Wheel & Steering Column) >> Repair Instructions >> Linear Shift Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Linear Shift Assembly
    GM1492305Courtesy of GENERAL MOTORS CORP.
  1. Install the linear shift assembly onto the steering column support assembly.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Secure the linear shift assembly to the steering column support assembly with the 3 oval head tapping screws.

    Move the linear shift assembly out of the PARK position to install the lower oval head tapping screw.

    Tighten:  Tighten the 3 TORX® screws to 10 N.m (89 lb in).

    3. Fig 2: View Of Automatic Transmission Shift Lock Control Actuator
    GM324906Courtesy of GENERAL MOTORS CORP.
  3. Install the automatic transmission shift lock control.

    Connect the automatic transmission shift lock control connector.

    4. Fig 3: Identifying Park Lock Cable At Ignition Lock Cylinder
    GM324874Courtesy of GENERAL MOTORS CORP.
  4. Connect the park lock cable assembly (1) to the ignition lock cylinder case in the following way:
    1. Place the steering column lock cylinder set into the OFF position.
    2. Place the shift lever tube into the park position.
    3. Press the locking tab on the end of the park lock cable assembly (1) into the slot in the ignition lock cylinder case.
  5. Install the shift lever. Refer to Shift Lever Replacement .
  6. Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement .
  7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals