LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H3 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Entertainment System) >> Repair Instructions >> Antenna Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Attach the mechanics wire to the end of the antenna cable.
    2. Fig 1: View Of Grommet & Cable
    GM1358256Courtesy of GENERAL MOTORS CORP.
  2. Pull on the mechanics wire to route the cable and grommet (1) through the hinge pillar.
    3. Fig 2: View Of Antenna Base & Screws
    GM1338048Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the screws retaining the antenna base.

    Tighten:  Tighten the screws to 7.5 N.m (66 lb in).

  4. Install the antenna mast. Refer to Fixed Antenna Mast Replacement .
    5. Fig 3: View Of Radio Antenna Cable
    GM1363155Courtesy of GENERAL MOTORS CORP.
  5. Remove the mechanics wire from the antenna cable (1).
  6. Install the grommet to the hinge pillar.
  7. Connect the radio antenna cable (1) to the extension cable.
  8. Install the I/P compartment door. Refer to Door Replacement - Instrument Panel (I/P) Compartment in Instrument Panel Gages and Console.
  9. Install the right hinge pillar trim panel. Refer to Trim Panel Replacement - Left Hinge Pillar in Interior Trim.
  10. Install the right front door sill plate. Refer to Door Sill Plate Replacement - Front in Interior Trim.
scientia non olet · About LEMON Manuals