LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H3 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Maintenance Reminder Light (Reset Procedures)) >> Tire Pressure Monitor System Reminder >> TPMS Reminder Reset - Procedure 17 >> Using DIC Reset Button

Using DIC Reset Button

WARNING: This page does not describe the selected car, but rather 2526 other vehicles, including the 2025 Honda Ridgeline, 2025 Honda Prologue, 2025 GMC Yukon XL, 2025 GMC Yukon, and 2025 GMC Terrain. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch to OFF position.
  2. Ensure all tire pressures are adjusted to the pressure recommended on tire pressure label.
  3. Turn ignition ON with engine OFF.
  4. Press SELECT right arrow button until "GAGE" is displayed.
  5. Press SELECT down arrow button until "TIRE PRESSURE" is displayed.
  6. Press and hold RESET button until "TIRE PRESSURE RESET" is displayed.
  7. Release RESET button. DIC should display "TIRE PRESSURE NORMAL".
  8. After resetting, the TPM system requires up to 30 minutes of straight line driving in each of the following speed ranges to complete calibration process:
    • 15-40 mph (24-64 km/h).
    • 40-70 mph (64-113 km/h).
    • 70-90 mph (113-145 km/h).
    NOTE: The EBCM learns tire pressure calibration for each speed range independently. In Monitor Mode 1, EBCM has only partially learned tire pressure calibration for speed range and has limited detection capability for a tire pressure condition. In Monitor Mode 2, EBCM has fully learned tire pressure calibration for speed range and has full detection capability for a tire pressure condition.
    NOTE: Learning process does not need to be completed during a single trip.
scientia non olet · About LEMON Manuals