LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Steering >> Steering Linkage >> Repair Instructions >> Tie Rod Replacement - Inner >> Installation Procedure

Installation Procedure

    Fig 1: Removing/ Installing Inner Tie Rods Ends
    GM865341Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
    IMPORTANT: Perform the following procedure before installing the new tie rod ends.
    • Remove all traces of the oil, grease, or other contaminants.
    • Clean the threads of the tie rod with denatured alcohol or the equivalent and allow to dry.
    • Apply Threadlocker GM P/N 12345493 or Canadian P/N 10953488 to the threads of the tie rod.
  1. Install the steering gear inner tie rod to the relay rod.

    Tighten:  Using the J 34028  (2) tighten the tie rod to 100 N. See Special Tools .m (74 lb ft).

  2. Install the steering linkage outer tie rods. Refer to Tie Rod Replacement - Outer .
  3. Install the engine protection shield. Refer to Engine Protection Shield Replacement .
  4. Adjust the front toe. Refer to Front Toe Adjustment .
scientia non olet · About LEMON Manuals