LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Wheel And Column >> Repair Instructions >> Upper Intermediate Steering Shaft Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Steering Column & Upper Intermediate Shaft
    GM731631Courtesy of GENERAL MOTORS CORP.
  1. Install the upper intermediate shaft to the vehicle.
  2. Connect the upper intermediate shaft to the steering column.
    3. Fig 2: Upper Intermediate Shaft & Lower Intermediate Shaft
    GM793256Courtesy of GENERAL MOTORS CORP.
  3. Connect the upper intermediate shaft to the lower intermediate shaft.
    4. NOTE: Refer to Fastener Notice .
  4. Install the upper intermediate shaft to the lower intermediate shaft pinch bolt.

    Tighten:  Tighten the upper intermediate shaft pinch bolt to 50 N.m (37 lb ft).

    5. Fig 3: View Of Upper Shaft To Steering Column Nut Bolt
    GM748880Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The upper intermediate shaft to the steering column pinch bolt must be installed in the same direction it was removed or the pinch bolt will contact the steering column housing.
  5. Install the upper intermediate shaft to the steering column pinch bolt and nut (1).

    Tighten:  Tighten the upper intermediate shaft to the steering column pinch bolt nut to 62 N.m (46 lb ft).

    6. Fig 4: Identifying J 42640
    GM333146Courtesy of GENERAL MOTORS CORP.
  6. Unlock the steering column by removing J 42640  from the steering column lower trim cover access hole.
scientia non olet · About LEMON Manuals