LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Wheel And Column >> Repair Instructions >> Steering Wheel Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Steering Wheel & Steering Wheel Shaft
    GM731652Courtesy of GENERAL MOTORS CORP.
  1. Install the steering wheel to the steering wheel shaft.
    2. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the retaining nut that secures the steering wheel to the steering wheel shaft.

    Tighten:  Tighten the retaining nut to 41 N.m (30 lb ft).

    3. Fig 2: Steering Wheel Electrical Connector
    GM731656Courtesy of GENERAL MOTORS CORP.
  3. Connect the steering wheel electrical connector.
  4. Install the horn plunger to the steering column.
  5. Install the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
  6. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals