LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Wheel And Column >> Repair Instructions >> Steering Column Seal Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Upper Intermediate Shaft Boot
    GM793261Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the steering column seal.

    Tighten:  Tighten the upper intermediate shaft to boot nuts to 50 N.m (37 lb ft).

    2. Fig 2: Upper Intermediate Shaft & Lower Intermediate Shaft
    GM793256Courtesy of GENERAL MOTORS CORP.
  2. Install the steering column seal nuts.

    Tighten  Tighten the nuts to 3 N.m (27 lb in).

  3. Connect the upper intermediate shaft to the lower intermediate shaft.
  4. Install the upper intermediate shaft to the lower intermediate shaft pinch bolt.

    Tighten:  Tighten the upper intermediate shaft pinch bolt to 50 N.m (37 lb ft).

    5. Fig 3: Identifying J 42640
    GM333146Courtesy of GENERAL MOTORS CORP.
  5. Unlock the steering column by removing J 42640  from the steering column lower trim cover access hole.
scientia non olet · About LEMON Manuals