LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Wheel And Column >> Repair Instructions >> Multifunction Turn Signal Switch Housing Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Turn Signal Switch Housing & Steering Column Shaft Assembly
    GM664269Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The turn signal switch housing must be pressed firmly against the steering column tilt head in order for the screws from the turn signal and multifunction switch assembly screws to line up.
  1. Slide the turn signal switch housing onto the steering column shaft assembly.
  2. Install the turn signal and multifunction switch assembly. Refer to Turn Signal Multifunction Switch Replacement .
  3. Install the ignition lock cylinder case. Refer to Ignition Lock Cylinder Case Replacement .
  4. Install the steering wheel onto the column. Refer to Steering Wheel Replacement .
  5. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About LEMON Manuals