LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Battery Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Battery & Insulator
    GM662922Courtesy of GENERAL MOTORS CORP.
  1. Install the battery insulator, if necessary.
  2. Install the battery.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  3. Install the battery hold down retainer and bolt.

    Tighten:  Tighten the battery hold down retainer bolt to 25 N.m (18 lb ft).

  4. Connect the positive battery cable.

    Tighten:  Tighten the positive battery cable bolt to 17 N.m (13 lb ft).

    5. Fig 2: View Of Negative Battery Cable At Battery
    GM832902Courtesy of GENERAL MOTORS CORP.
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals