LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Vehicle Access >> Repair Instructions >> Endgate Latch and Cable Assembly Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Endgate Shouldered Latch Bolt
    GM1428021Courtesy of GENERAL MOTORS CORP.
  1. Position the endgate cable to the lower latch assembly.
    2. NOTE: Refer to Fastener Notice .
  2. Ensure the shouldered bolt (1) is used on the latch cable assembly end.

    Tighten:  Tighten the bolt to 25 N.m (19 lb ft).

  3. Raise the endgate in order to secure the cable assembly (2) to the endgate box rail bolt.
    4. Fig 2: Endgate Support Cable
    GM1486510Courtesy of GENERAL MOTORS CORP.
  4. Secure the cable.
  5. Repeat for the other side.
  6. Close the endgate.
  7. Latch and secure the spare tire carrier.
scientia non olet · About LEMON Manuals