Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.

Insert a new seal into the intake manifold groove.

Fig 1: View Of Throttle Control Module

Courtesy of GENERAL MOTORS CORP.

Position the throttle control module (2) to the intake manifold.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the throttle control module bolts (1).
Tighten: Tighten the throttle control module bolts to 10 N.m (89 lb in).

Fig 2: View Of Throttle Control Module Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the throttle control module electrical connector (2).

Fig 3: View Of EVAP Canister Purge Pipe, Throttle Body Module & EVAP Canister Purge Solenoid Valve

Courtesy of GENERAL MOTORS CORP.

Connect the EVAP canister purge pipe (1) to the throttle control module (2). Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
Install the air cleaner resonator and outlet duct. Refer to Air Cleaner Resonator and Outlet Duct Replacement .