LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2006 >> H3 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Engine Control System - 2.8L (LK5) - Introduction) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Canyon and 2005 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of FTP Sensor
    GM1361717Courtesy of GENERAL MOTORS CORP.
  1. Lightly lubricate the FTP sensor seal with clean engine oil.
  2. Press the FTP sensor fully into the fuel tank module.
  3. Fig 2: View Of FTP Sensor, Electrical Connector, Fuel Tank Module & Fuel Wiring Harness Retainer
    GM1361711Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector (2) to the FTP sensor (1).
  5. Install the left pickup box wheelhouse liner. Refer to Pickup Box Wheelhouse Liner Replacement in Body Rear End.
  6. Lower the vehicle.