LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2006 >> H3 Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.5L - Introduction (2 Of 2) >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

  1. Insert a new seal into the intake manifold groove.
    2. Fig 1: View Of Throttle Body Assembly
    GM742490Courtesy of GENERAL MOTORS CORP.
  2. Position the throttle control module (2) to the intake manifold.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the throttle control module bolts (1).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    4. Fig 2: View Of Engine Wiring Harness Connections To Camshaft Cover & Throttle Body
    GM1350717Courtesy of GENERAL MOTORS CORP.
  4. Connect the throttle control module electrical connector (2).
    5. Fig 3: View Of EVAP Canister Purge Pipe, Throttle Body Module & EVAP Canister Purge Solenoid Valve
    GM1352026Courtesy of GENERAL MOTORS CORP.
  5. Connect the EVAP canister purge pipe (1) to the throttle control module (2). Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  6. Install the air cleaner resonator and outlet duct. Refer to Air Cleaner Resonator and Outlet Duct Replacement .
scientia non olet · About LEMON Manuals