LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2006 >> H3 Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.5L - Introduction (2 Of 2) >> Repair Instructions >> Engine Coolant Temperature (ECT) Sensor Replacement >> Removal Procedure

Removal Procedure

  1. Partially drain the engine coolant below the level of the engine coolant temperature (ECT) sensor. Refer to Draining and Filling Cooling System in Engine Cooling.
    2. Fig 1: View Of ECT Sensor Electrical Connector
    GM1352005Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the ECT sensor electrical connector (2) from the following:
    • The engine wiring harness
    • The camshaft cover (1)
    3. NOTE: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.
  3. Using the J 45861  (4) carefully remove the ECT sensor (3) from the cylinder head (5). See Special Tools .
scientia non olet · About LEMON Manuals