LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2006 >> H3 Automatic >> Repair and Diagnosis >> Engine Mechanical >> Engine Exhaust >> Repair Instructions >> Catalytic Converter Heat Shield Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Catalytic Converter Heat Shield At Floor Panel
    GM1560124Courtesy of GENERAL MOTORS CORP.
  1. Position the catalytic converter heat shield to the floor panel studs.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nuts securing the heat shield to the floor panel.

    Tighten:  Tighten the nuts to 9 N.m (80 lb in).

  3. Lower the vehicle.
scientia non olet · About LEMON Manuals