LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2006 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Steering >> Power Steering System >> Repair Instructions >> Steering Gear Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Power Steering Gear
    GM793263Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the steering gear to the frame and install the retaining bolts.

    Tighten:  Tighten the steering gear retaining bolts to 150 N.m (111 lb ft).

  2. Install the pitman arm. Refer to Pitman Arm Replacement in Steering Linkage.
  3. Install the engine protection shield. Refer to Engine Protection Shield Replacement in Frame and Underbody.
  4. Remove the safety stands.
  5. Lower the vehicle.
  6. Install the intermediate shaft to the steering gear. Refer to Lower Intermediate Steering Shaft Replacement in Steering Wheel and Column.
  7. Remove the caps or plugs from the steering gear and hoses.
  8. Install the hoses to the steering gear.

    Tighten:  Tighten the hoses fittings to 28 N.m (21 lb ft).

  9. Bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals