LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2006 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Wheel And Column >> Repair Instructions >> Steering Column Seal Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Upper Intermediate Shaft Boot
    GM793261Courtesy of GENERAL MOTORS CORP.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  1. Install the upper intermediate shaft boot.

    Tighten:  Tighten the upper intermediate shaft to boot nuts to 50 N.m (37 lb ft).

    2. Fig 2: Upper Intermediate Shaft & Lower Intermediate Shaft
    GM793256Courtesy of GENERAL MOTORS CORP.
  2. Connect the upper intermediate shaft to the lower intermediate shaft.
  3. Install the upper intermediate shaft to the lower intermediate shaft pinch bolt.

    Tighten:  Tighten the upper intermediate shaft pinch bolt to 50 N.m (37 lb ft).

    4. Fig 3: Identifying J 42640
    GM333146Courtesy of GENERAL MOTORS CORP.
  4. Unlock the steering column by removing J 42640  from the steering column lower trim cover access hole.
scientia non olet · About LEMON Manuals