Installation Procedure

IMPORTANT: Perform the following procedure before installing the new tie rod ends.

Remove all traces of the oil, grease, or other contaminants.
Clean the threads of the tie rod with denatured alcohol or the equivalent and allow to dry.
Apply Threadlocker GM P/N 12345493 or Canadian P/N 10953488 to the threads of the tie rod.

Fig 1: Inner Tie Rods Ends

GM865341

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the inner tie rod to the relay rod.
Tighten: Using theJ 34028 tighten the tie rod to 100 N.m (74 lb ft). See Special Tools and Equipment .
Install the outer tie rod assemblies. Refer to Tie Rod Replacement - Outer .
Install the engine protection shield. Refer to Engine Protection Shield Replacement in Frame and Underbody.
Lower the vehicle.
Verify the wheel alignment. Refer to Wheel Alignment Specifications in Wheel Alignment.