LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2004 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Steering >> Steering Linkage (Non-Rack & Pinion) >> Repair Instructions >> Idler Arm Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Idler Arm
    GM793272Courtesy of GENERAL MOTORS CORP.
  1. Position the idler arm on the frame.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the frame bolts and the nuts to the idler arm.

    Tighten:  Tighten the frame bolts to 120 N.m (89 lb ft).

  3. Install the relay rod to the idler arm ball stud.

    Ensure the seal is on the stud.

    4. Fig 2: Seating The Idler Arm Tapers
    GM689037Courtesy of GENERAL MOTORS CORP.
  4. Use the J 29193  or the J 29194  in order to seat the tapers. See Special Tools and Equipment .

    Tighten:  Tighten the J 29193  or the J 29194  to 54 N.m (40 lb ft) in order to seat the tapers. See Special Tools and Equipment .

  5. Install the new idler arm ball stud prevailing torque nut to the idler arm ball stud.

    Tighten:  Tighten the nut to 60 N.m (44 lb ft).

  6. Install the engine protection shield. Refer to Engine Protection Shield Replacement in Frame and Underbody.
  7. Lower the vehicle.
  8. Check the wheel alignment. Refer to Wheel Alignment Specifications in Wheel Alignment.
scientia non olet · About LEMON Manuals