LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2004 >> H2 4D Utility Pickup >> Repair and Diagnosis >> External Pages >> Different car >> Section 730 (Engine Mechanical) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Mount (Left)
    GM794679Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  1. Position the right engine mount to the engine. (Left side shown, right side similar).
  2. Install the engine mount bolts.

    Tighten:  Tighten the engine mount bolts to 50 N.m (37 lb ft).

  3. Lower the engine.
  4. Remove the adjustable jack stands.
  5. Install the starter motor. Refer to STARTER MOTOR REPLACEMENT .
  6. Install the A/C compressor. Refer to COMPRESSOR REPLACEMENT .
    7. Fig 2: Engine Protection Shield
    GM794711Courtesy of GENERAL MOTORS CORP.
  7. Position the engine shield to the vehicle.
  8. Install the engine shield bolts.

    Tighten:  Tighten the engine shield bolts to 30 N.m (22 lb ft).

  9. Lower the vehicle.
    10. Fig 3: Engine Mount-To-Frame Bracket Bolts (Left)
    GM794678Courtesy of GENERAL MOTORS CORP.
  10. Install the engine mount-to-frame bracket bolts.

    Tighten:  Tighten the engine mount-to-frame bracket bolts to 65 N.m (48 lb ft).

scientia non olet · About LEMON Manuals