LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2004 >> H2 4D Utility Pickup >> Repair and Diagnosis >> External Pages >> Different car >> Section 721 (Body Rear End) >> Repair Instructions >> Strut Replacement - Liftgate >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Hood Hold-Open Device Caution in Cautions and Notices.
    NOTE: Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result.
  1. Open the liftgate.
  2. Support the liftgate.
  3. Carefully pry the retaining clip in order to remove the lower end of the liftgate strut (1) from the ball stud on the body.
  4. Carefully pry the retaining clip in order to remove the upper end of the liftgate strut (2) from the ball stud on the liftgate.
    Fig 1: Installing Upper & Lower Ends Of Liftgate Strut
    GM831422Courtesy of GENERAL MOTORS CORP.
  5. Remove the liftgate strut from the vehicle.
scientia non olet · About LEMON Manuals