LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2004 >> H2 4D Utility Pickup >> Repair and Diagnosis >> External Pages >> Different car >> Section 721 (Body Rear End) >> Repair Instructions >> PULLSTRAP Replacement - Liftgate >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Liftgate Pullstrap
    GM833485Courtesy of GENERAL MOTORS CORP.
  1. Install the pullstrap to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the screw that retains the pullstrap to the liftgate.

    Tighten:  Tighten the screw to 1.5 N.m (13 lb in).

scientia non olet · About LEMON Manuals