LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2004 >> H2 4D Utility Pickup >> Repair and Diagnosis >> External Pages >> Different car >> Section 721 (Body Rear End) >> Repair Instructions >> Lock Plate & Rod Replacement - Liftgate >> Installation Procedures

Installation Procedures

WARNING: This page is about a different car, the 2003 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: Liftgate Lock Plate & Rod
    GM831459Courtesy of GENERAL MOTORS CORP.
  1. Position the lock plate assembly in place on the liftgate, and install the fasteners (1) retaining the control assembly to the liftgate.

    Tighten:  Tighten the fasteners to 9 N.m (7 lb ft).

  2. Connect the latch control cables (2) to the control assembly by placing the cable ends in their cups and securing the retainers. Note the proper routing.
  3. Connect the lock actuator electrical connector.
  4. Inspect for proper operation.
  5. Install the liftgate trim panel. Refer to Trim Panel Replacement - Liftgate  .
scientia non olet · About LEMON Manuals