Installation Procedure
WARNING: This page is about a different car, the 2003 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Install the bulb to the socket.
- Install the bulb socket to the lamp.
- Install the lamp to the vehicle.
- Install the screws to the lamp.
Tighten: Tighten the screws to 3 N.m (26 lb in).
- Connect the electrical connector.
- Install the bezel and lamp to the license plate pocket.
- Install the screws to the license pocket bezel.
Tighten: Tighten the screws to 3 N.m (26 lb in).
NOTE:
Refer to Fastener Notice in Cautions and Notices.