LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2004 >> H2 4D Utility Pickup >> Repair and Diagnosis >> External Pages >> Different car >> Section 227 (Starters) >> Removal & Installation >> Starter Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the starter heat shield.
  2. Snap the transmission cover to the starter.
  3. Install the positive cable to the starter.
  4. Install the positive cable nut. Tighten the positive cable nut to 9 N.m (80 lb in).
  5. Install the starter lead to the starter.
  6. Install the starter lead nut. Tighten the starter lead nut to 3.4 N.m (30 lb in).
  7. Position the starter into place.
  8. Install the starter bolts. Tighten the starter bolts to 50 N.m (37 lb ft).
  9. Connect the oil level sensor electrical connector.
  10. Install the transmission cover bolt. Tighten the transmission cover bolt to 9 N.m (80 lb in).
  11. Install the engine protective shield.
  12. Lower the vehicle.
  13. Connect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE (SINGLE BATTERY) .
scientia non olet · About LEMON Manuals