LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2004 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Starter Motor Replacement >> Removal Procedure

Removal Procedure

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
    Fig 1: View Of Negative Battery Cable At Battery
    GM832902Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure (Single Battery) .
  2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    3. Fig 2: View Of Transmission Cover Bolt
    GM663487Courtesy of GENERAL MOTORS CORP.
  3. Remove the engine protective shield. Refer to Engine Protection Shield Replacement .
  4. Remove the transmission cover bolt.
    5. Fig 3: Starter Bolts
    GM663527Courtesy of GENERAL MOTORS CORP.
  5. Remove the starter bolts.
  6. Disconnect the oil level sensor electrical connector.
  7. Slide the starter forward until the starter clears the transmission.
    8. Fig 4: Identifying Electrical Connector (Right Side Of Engine)
    GM662991Courtesy of GENERAL MOTORS CORP.
  8. Remove the starter lead nut (3).
  9. Remove the starter lead (2) from the starter.
    10. Fig 5: Positive Cable Nut
    GM759622Courtesy of GENERAL MOTORS CORP.
  10. Remove the positive cable nut (2).
  11. Remove the positive cable from the starter.
    12. Fig 6: Transmission Cover & Starter
    GM663489Courtesy of GENERAL MOTORS CORP.
  12. Place the starter on a workbench.
  13. Unsnap the transmission cover from the starter.
    14. Fig 7: View Of Starter & Heat Shield
    GM663472Courtesy of GENERAL MOTORS CORP.
  14. Remove the starter heat shield.
scientia non olet · About LEMON Manuals