Installation Procedure

Fig 1: Rear Door Latch

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Place the latch (1) into position in the door, and install the 3 fasteners (2) that retain the latch to the door.
Tighten: Tighten the fasteners to 9 N.m (7 lb ft).

Fig 2: Manual Locking Rod

Courtesy of GENERAL MOTORS CORP.

Install the manual locking rod (1) to the door by securing the rod in the retainers (2).

Fig 3: Rear Outside Door Handle Rod

Courtesy of GENERAL MOTORS CORP.

Connect the outside door handle rod (1) by securing the rod in the retaining clip on the door latch.
Connect the lock actuator electrical connector.
Operate the door handle functions to ensure proper operation.
Install the window run channel. Refer to Window Run Channel Replacement - Rear Door .
Install the water deflector. Refer to Water Deflector Replacement - Rear Door .
Install the door trim panel. Refer to Trim Panel Replacement - Side Rear Door .