Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Refer to Hood Hold Open Device Caution in Cautions and Notices.

NOTE: When removing body panels, apply tape to corners of panel and adjacent surfaces to help prevent paint damage.

Fig 1: View Of Under Hood Light Electrical Wire Connector

Courtesy of GENERAL MOTORS CORP.

Disconnect the under hood light electrical wire connector located on the passenger side front of the lower radiator support.

Fig 2: Struts At Upper Ball Studs

Courtesy of GENERAL MOTORS CORP.

Mark the location of the hinges on the frame rails using a grease pencil.
With the aid of a helper, support the hood assembly.
Remove the struts from the upper ball studs.
Pry outward on the retaining clip and pull the strut from the ball stud.

Fig 3: Hinge To Frame Rail Nuts

Courtesy of GENERAL MOTORS CORP.

Remove the nuts attaching the hinge to the frame rail.

Fig 4: Insulator & Push-In Fasteners

Courtesy of GENERAL MOTORS CORP.

Remove the hood.
Transfer parts as necessary.