LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 640 (Lighting Systems) >> Repair Instructions >> Headlamp Bezel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Headlamp Bezel To Headlamp Opening Door
    GM64647Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The headlamp bezel has a tab (3) which fits into a retaining clip (2) on the underside of the headlamp opening door (1). Observe caution when installing the headlamp bezel.
  1. Pull the rear sides of the bezel out slightly.
  2. Position the headlamp bezel to the headlamp, inserting the bezel tab (3) into the retaining clip (2) on the underside of the headlamp opening door (1).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the screws to the side of the headlamp bezel.

    Tighten:  Tighten the headlamp bezel retaining screws to 2 N.m (18 lb in).

    4. Fig 2: RH Headlamp Wiring Harness Electrical Connector To Forward Lamp Wiring Harness
    GM64644Courtesy of GENERAL MOTORS CORP.
  4. Connect the headlamp wiring harness electrical connector to the forward lamp wiring harness.
  5. Rotate the headlamp motor/actuator manual control knob clockwise to lower the headlamp.
  6. Install the rear screw to the headlamp bezel.

    Tighten:  Tighten the headlamp bezel retaining screw to 2 N.m (18 lb in).

    7. Fig 3: Headlamp Actuator Knob Cover
    GM777768Courtesy of GENERAL MOTORS CORP.
  7. Install the motor/actuator knob cover.
  8. Close the hood.
scientia non olet · About LEMON Manuals