Installation Procedure
WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Install the upper control arm.
- Install the upper control arm bolts.
Tighten: Tighten the nuts to 190 N.m (140 lb ft).
- Connect the upper control arm to the steering knuckle.
- Install the wheel drive shaft. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.
- Install the new nut to the upper ball joint stud.
Tighten: Tighten the nut to 50 N.m (39 lb ft).
- Install the retaining bolts for the brake hose and wheel speed sensor brackets.
Tighten: Tighten the bolts to 9 N.m (80 lb in).
- Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Lower the vehicle.
- Verify the wheel alignment. Refer to Wheel Alignment Specifications in Wheel Alignment.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.