LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 614 (Disc Brake System) >> Repair Instructions >> Disc Brake Backing Plate Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the park brake cable automatic adjuster. Disabling the Park Brake Cable Automatic Adjuster in Park Brake.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  4. Remove the rear park brake cable from the park brake actuator lever.
  5. Remove the park brake cable from the mounting bracket by depressing the locking tabs.
  6. Remove the rotor. Refer to Brake Rotor Replacement - Rear  in Disc Brakes.
  7. Remove the axle shaft. Refer to Rear Axle Shaft Replacement in Rear Drive Axle.
  8. Remove the park brake shoe. Refer to Park Brake Shoe Replacement .
    9. Fig 1: View Of Backing Plate & Nuts - Rear
    GM370688Courtesy of GENERAL MOTORS CORP.
  9. Remove the backing plate nuts.
  10. Remove the backing plate from axle housing flange.
scientia non olet · About LEMON Manuals