LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 587 (Transfer Case - BW 4484) >> Repair Instructions >> Transfer Case Shift Control Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Shift Control/Selector Switch
    GM860516Courtesy of GENERAL MOTORS CORP.
  1. Position the selector switch close to the housing so the electrical connectors can be connected.
  2. Connect the selector switch electrical connectors.
  3. Slide the selector switch into the housing until the switch snaps into place.
    IMPORTANT: Make sure that the selector switch is seated properly in the housing before installing the I/P cluster bezel.
  4. Install the I/P cluster bezel. Refer to Trim Panel Replacement - Instrument Panel (I/P) Center in Instrument Panel, Gauges, and Console.
scientia non olet · About LEMON Manuals