LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2003 >> H2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 567 (Entertainment System) >> Repair Instructions >> Antenna Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the hood.
    2. Fig 1: Front Fender Upper Hole Cover
    GM1415780Courtesy of GENERAL MOTORS CORP.
  2. Remove the antenna mast boot (1).
  3. Remove the antenna mast (2).
  4. Remove the 2 screws (3) retaining the front fender upper hole cover.
  5. Remove the front fender upper hole cover (4).
    6. Fig 2: Fastener & Mast Base
    GM1415783Courtesy of GENERAL MOTORS CORP.
  6. Remove the 3 screws (1) retaining the mast base.
  7. Remove the fastener (2) from the mast base.
  8. Remove the right front sill plate. Refer to Door Sill Plate Replacement - Front in Interior Trim.
  9. Remove the right kick-up panel. Refer to Kick-Up Panel Replacement - Front Floor in Interior Trim.
    10. Fig 3: Antenna Cable & Extension Cable
    GM1416172Courtesy of GENERAL MOTORS CORP.
  10. Disconnect the antenna cable (1) from the extension cable (2).
  11. Attach a mechanics wire to the antenna cable (1).
  12. Remove the antenna cable leaving the mechanics wire in place.
  13. Remove the antenna cable assembly from the vehicle.
scientia non olet · About LEMON Manuals