Installation Procedure

WARNING: This page is about a different car, the 2004 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Place the check link in position in the door.

Fig 1: Rubber Grommet & Front Door Check Link Opening

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the nuts (2) that retain the check link to the door.
Tighten: Tighten the nuts to 9 N.m (7 lb ft).
Replace the rubber grommet in the door check link opening (1).

Fig 2: Front Door Check Link Fasteners

Courtesy of GENERAL MOTORS CORP.

Install the fasteners (1) that retain the check link to the vehicle.
Tighten: Tighten the fasteners to 9 N.m (7 lb ft).
Install the water deflector. Refer to Water Deflector Replacement - Front Door or Water Deflector Replacement - Rear Door .
Install door trim panel. Refer to Trim Panel Replacement - Side Front Door or Trim Panel Replacement - Side Rear Door .